ASSEMBLY INSTRUCTIONS
Mounting Racks on fixing bar
-
Get a drill, a spirit level, a screwdriver, a tape measure and a pencil.
-
Locate the center distance of the holes on the fixing bar and transfer the measurement to your wall, remembering to check the level.
-
Drill and install appropriate anchors for your wall.
-
Install the bar fixing with the spacers using screws; these must pass through the fixing bar and the spacer. It is recommended to use screws of at least 50 mm in length.
-
You can now hang your rack and place your equipment on it.
Assembly of the “Knobs”
-
Get a drill, a spirit level, a screwdriver, a tape measure and a pencil.
-
Take the measurement (width) approximately 10 cm below the widest point of your tip (ski or snowboard) and add 18 mm to the result obtained; This is your drill center distance. Don't forget to check the level.
-
Drill and install appropriate anchors for your wall.
-
Install the “knobs” with the spacers using screws; these must pass through the fixing bar and the spacer. It is recommended to use screws of at least 50 mm in length.
-
You can now hang your skis or snowboard.